2.4~2.5GHz Wireless Audio/Video Sender User Manual SR-09 Package Contents
9 2. Position the receiver so that your remote control signal can strike the IR window on the front of the receiver. Set the remote antenna on t
10 modulator (3 or 4). If the signal is poor, or there is interference • Adjust the transmitter by rotating orientations until you get the best
11 caused by unauthorized modifications to this equipment. Such modifications could void the user's authority to operate the equipment.
1 • Transmitter x 1 • Receiver x 1 • Infrared (IR) eye cable x 1 • Audio/Video cable x 2 • Power adaptors (DC6V) x 2 • User manual x 1 Note: The
2 Setting Up Before you make the connection: • Set the channel by pressing the select button on the front of the tran
3 A/V Connection Connect the mini-plug of the provided A/V cables to the A/V jack on the rear of the transmitter; connect the other end of the cable
4 Note 1: On a NTSC system, the connector on the A/V equipment is an RCA jack. Connect the yellow plug to the jack labeled VIDE
5 2. Setting up the Receiver 2.1 Connect the Receiver to a TV A/V Connect – for TV with A/V Input Jacks Conn
6 RF Connection – for TV without A/V Input Jacks If there is no A/V input jacks on your TV, you will need to get an RF modulator (available at your
7 Note 1: Connect the yellow plug to the jack labeled VIDEO, the red plug to the jack labeled AUDIO RIGHT and the white plug to th
8 Other Applications Using Remote Control The Wireless A/V Sender gives you the ability to control A/V components from another room using your exist
Comments to this Manuals